Enter your keyword

PRETREAT 5530 ( MEMBRANE BIOCIDE )

PRETREAT 5530 ( MEMBRANE BIOCIDE )

Product Description Pretreat 5530 is a fast acting, broad – spectrum biocide used for cleaning Reverse Osmosis and Nano filtration membranes. It can be used both on and off- line to eliminate microbiological fouling. When used in potable water applications, Pretreat 5530 should be used ‘off-line’. It is also effective in removing biofilm from pumps, tanks and
pipe-work. Best results are obtained when Pretreat 5530 is used at a pH 5.5 – 7.0. it can be deactivated to harmless byproducts by using sodium bisulphate. Pretreat 5530 is readily biograded in the environment: the degradation rate is enhanced at increasing pH and temperature.
Physical Properties pH (Neat) : 6
Form : Clear, Colorless, homogeneous liquid
Sp., Gravity: 1.0
Solubility: Soluble in water in all proportions
Typical Dosage The dose requirement and the cleaning procedure shall be recommended by Sri Amman chemicals technical representatives after assessing the extent of fouling and the operating conditions of the system.
Handling & Safety Pretreat 5530 should be handled like any other industrial chemical such as, acids or alkalis. Safety shoes, gloves and face masks should be worne while handling the product. Direct contact with skin should be avoided. In case of accidental splash, wash the affected area with plenty of fresh water and get immediate medical attention. In case of spills, wash the area with plenty of water.
Environmental safety Pretreat 5530 contains ingredients, which are non toxic and non polluting at suggested use levels. They are auto degradable and bio degradable. Water treated with Pretreat 5530 can be safely discharged into any waste stream, without need for any post treatment.
Storage Pretreat 5530 should be stored in a cool, dry place, away from direct sunlight, sources of heat or moisture.
Shipping Pretreat 5530 is shipped in 25/ 50liters HDPE containers

Important: Information given above are in good faith and for the benefit of the user only. Physical properties are indicative and are to vary. However, this shall not influence the product performance.

POST YOUR COMMENT